facebook rss twitter

Review: Antec Sonata III PC system case

by Matt Davey on 30 October 2007, 08:39

Tags: Sonata III, Antec, PC

Quick Link: HEXUS.net/qaj4j

Add to My Vault: x

Inside the belly of the beast

The inside of the Sonata III is concerned with functionality not fancy stuff. It's rather bare, with little in the way of luxuries.

 Antec Sonata III 500

Beneath the five externally-accessible drive bays are four internal 3.5in HDD bays. They're mounted at 90 degrees to the front of the chassis, for easy access and each comes with its own removable drive-tray.

 Antec Sonata III 500


The four HDD trays come pre-fitted with rubber grommets but they didn't seem to make much impact on dampening hard disk noise - it was easily audible from outside of the chassis.

Oh and on the subject of noise - remember we spoke about the absent front fan? Well, perhaps that goes some way to explaining the ‘quiet PC’ moniker that the Sonata III 500 carries.

On the up side, the lone 120mm fan that is fitted - at the rear - is one of Antec's impressive tri-cool units. However, it's powered via a Molex connector, making it a little harder to keep the interior tidy.

 Antec Sonata III 500


The fitted power supply is a 500W unit (hence the 500 name-tag), and that's a 50W improvement over the PSU fitted to the Sonata II. The PSU boldly displays an 80+ performance efficiency sticker and is a member of Antec's EarthWatts range.

It was quiet in use and, since it comes fitted as standard, we left it in place for our thermal tests.